![]() ![]() Best part? Never dirty! I wouldn't do a pool without one again. ![]() I never need to top off the pool (Unless we have a lot of splashing), stays warmer, and uses less chemicals. If we weren't out there, the cover was on.īut I had no idea it would pay for itself many times over in saving frustrations. I found all the documents (That they never provided me) and adjusted the clutch and it works great now.Īnyway, with all that said, we did the cover for safety. Unfortunately, they're the only game in town. Like two months later, I get a bill for $700 if I recall. I noticed no difference in the cover and how it operated. I was away from the house for just under an hour and supposedly came then. Scheduled them and was told they'd be out a particular day. They said I needed to replace the pulleys. It's not horrible.īut very happy with ours (Not happy with the installer/maintenance company.) Ours is going on 10 years and I had the maintenance company out once because the cover was running slow and making noise. Note : The pre-assembled hardware on the axis takes into account the motors dimensions.We opted for the auto cover when we built our pool, so it's below deck (But the tracks are above deck.) We found out because a neighbor has this, but theirs was installed after the fact and the box is on the deck. If the pool itself is not straight, this will also cause the shutter covers slats to be out of line. If this is the case, unrolling will equally cause friction with pool wall with the shutter cover. This causes the layers of slats to be out of line. Incorrect positioning will provoke the incorrect rolling of the cover. The straps should be fitted in their respective supports which can be adjusted in relation to the shutter cover. The first module of the slats is equipped with weaved nylon straps 50mm wide. Once the shutter cover has been assembled, it should be fixed to the rolling axis. To simplify assembly, the slats should be placed, by module, on water.įixation of the shutter cover on the axis This module should be positioned at the extremity of the shutter cover which is opposite to the rolling axis. ![]() One of the modules is equipped with obliged security straps. The other slats are delivered in modules of 3 or 6 elements. The first module of the shutter is delivered with fixation straps attached to the axis. The slats must be stocked in the shade, with an air temperature lower than 40°c. The assembly of the shutter can only be undertaken if there is water in the pool. If this option is used it must be installed in a position where the pool is visible during each opening and closing unit.ĭuring the installation, if the key control cable terminals are inverted and the shutters action does not correspond to the open and close position on the box, cross the cable terminals "F and O" in the control box. Internal installation within the reccomended protection volumeįorwards/backwards and on/off command by holding the key contact in position (Norm NF P90-308).įorwards/backwards and on/off command by holding the key contact in position to open and close the shutter by one impulsion on the key (Norm NF P90-308).Estimated rolling time for pools measuring 8 x 4m : 1'30 min.Weight: 1 lbs: Dimensions: 1 × 1 × 1 in: Brand: Automatic Pool Covers. Motor coupling 150nm or 250nm depending on pool size Try one of our automatic pool covers today or give us a call with questions Open: Monday-Friday 7am-6pm Phone: 80 email protected Pool Warehouse, We Know In-ground Swimming Pool Kits Additional information.Sealed motor contained in the axis with limit management Rolling time for pool 8 x 4m : 1'30 min.Delivered pre-assembled on axis supports.Sealed motor contained in the axis without limit management Diameter : 140 or 155mm for pools greater than 10 x 5m.Material : reinforced andonised aluminium.Fixations : 2 x 4 stainless steel screws m8 x 90 on brass pegs.Material : stainless steel 304, thermo laquered in white,. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |